HakkoUSA Knowledge Base

How long do the carbon brushes in my AT Brush Series driver last?...

What Hakko Products Do Not Require Calibration?

Why is there a small notch in my CHP-170 cutter?

Why is my USB flash drive not accessible to the ATX Controller?

What material is the A1566 resin cleaning brush made from?

What material are handles for CHP hand tools made from?

Can I change the sample rate of the tip temperature data...

Why does my soldering iron not sit properly in its holder?

How to reset the calibration of the DPC Touch v2

Replacement for older 485 analog temperature controller

What is the base material for the crucibles used by the FX-30x...

Purchased a 936-RC-B (936-13) soldering station. The unit works...

What is the maximum operating temperature for Loc-Line duct?

What are the HMIS markings for the HAKKO A1586 Main Filter

Can I use Li-ion batteries in my HAKKO FX-901 Cordless Soldering...

How to add and offset Value to your 485 unit

Is my FX-300 solder pot ESD safe ?

Upgrading your FR-4101 desoldering hand piece to an FR-4103...

Upgrading your FR-4102 to an FR-4104 hand piece

Cleaning and maintenance of a 485 Solder fountain

How do I perform a factory reset on the HAKKO FX-100 Soldering...

Minimum Temperature Accuracy for T52 Series Tips

What is the resistance value for a good heating element in a...

Are there any safety concerns when using the HAKKO FX-780 or...

What is the ground port on the FM-206 used for?

What does the suffix mean on the CHP cutters?

What is the operating temperature for the HAKKO RED (503)...

What is the HAKKO FS-100 Tip Polish and how do I use it?

Can I use my HAKKO FX-1001 Soldering Iron Handpiece and T31...

Why do the ends of new soldering iron tips in the package not...