Search

HakkoUSA Knowledge Base

Why is my mill bit too low for the guide on my DPF-300?

Chris Stuber
Depaneling Systems

The mill bit of the DPF-300 is secured in the ER11 collet on the spindle and at the bottom of the collet is a spacer pin that is 3mm in diameter and 10mm long. If this spacer pin is missing, the mill bit will not sit at the proper height when the guide is installed.
 
Details
Article ID: 12153
Last Modified: 3 Months Ago
Last Modified By: Chris Stuber
Type: INFO
Article not rated yet.
Article has been viewed 433 times.
Options
Also In This Category