Menu

Search

HakkoUSA Knowledge Base


Why does the A1559 Sponge look different than the drawing in the user manual?


Chris Stuber
General FAQs

The A1559 Sponge used in the FH-800 Iron holder that comes with the HAKKO FX-888D Soldering Station, is a compressed material that is die-cut from a large sheet of material.  This die cutting scores two semi-circular areas of the sponge material that are adjacent to the elongated openings in the sponge.

When you install a new sponge, it is best to dampen the sponge with de-ionized or distilled water and squeeze out any excess water.  Then, remove the two semi-circular areas of the sponge and place them in the bottom of the sponge tray of the iron holder.  These small pieces of sponge will absorb water from the bottom of the sponge tray and will aid in keeping the main sponge damp through capillary action.

The drawing that you see in the user manual shows the sponge AFTER the semi-circular areas have been removed and installed in the iron holder, while the online picture of the sponge shows the sponge after it has expanded from contact with water and WITH the semi-circular areas still attached. 

Also In This Category


On a scale of 1-5, please rate the helpfulness of this article


Not Helpful
Very Helpful
Optionally provide private feedback to help us improve this article...

Thank you for your feedback!


Still have questions - Submit a new ticket
Details
Article ID: 10609
Last Modified: 7 Years Ago
Last Modified By: Chris Stuber
Type: INFO
Rated 2 stars based on 2 votes.
Article has been viewed 10K times.
Options
Find Similar